Parking Lot Striping Ottawa, KS

Ottawa, Kansas Parking Lot Striping

Ottawa is a city situated along the Marais des Cygnes River in east-central Kansas, 50 miles southwest of Kansas City, A.M.  The city population was 12,649 in the 2010 census. It is the county seat and most populous city of Franklin County. Ottawa is included in the Kansas City Metropolitan Area.

The town grew up around Ottawa Indian settlements. The tribe lived in the area from 1837 to 1867 and donated land for Ottawa University. The university and town were named for the tribe.
​
The city of Ottawa has a history of flooding due to the Marais Des Cygnes river. 
​

Fun Things To Do In Ottawa, KS

• Old Depot Museum
• Forest Park
• Kanza Park
• Carnegie Cultural Center
• Plaza Cinemagic Experience
• Sandbar
• Ottawa Bike Trail
• Ottawa University

​

Ottawa University is a private Baptist  liberal arts university in Ottawa, Kansas.  There are several satellite campuses in different locations throughout the United States. It was founded in 1865 and is affiliated with the American Baptist Churches USA.

Speed Bumps in Your Parking Lot

• ​What are speed bumps & which one you should get installed in your parking lot 

Speed bumps belong to the category of traffic control devices which are used to slow down the speed of the traffic. These are used all over the world, and their primary use is in areas where a low-speed limit needs to be followed. The speed bumps have proven to be very useful in controlling the speed of the cars. The height of a usual speed bump lies between 3 to 4 inches. The length of the bumps can vary however usually some space is left between the bump and the edge of the road. There are many other variations when it comes to speed controlling devices on the way some of which are speed humps, speed cushion, and speed table. 
​

• Why you need to hire a professional 

Speed bumps are made of rubber, plastic, asphalt, metal or concrete. If they are made of rubber or plastic, it is easy to get them installed on pre-existing surfaces and give an instant and effective setup. These options are lightweight and can be fixed temporarily. Despite being a simple task, there are some basic instructions that need to be followed before installation, which can otherwise cause a severe accident. 

The surface where the bump will be fitted should be clean, dry, and smooth. If there are any damages, they should be repaired before the speed ramps are installed. Speedbumps should lie flat on the surface. Once the position is marked, road humps should be drilled and fitted on the ground. 

When Do You Replace Speed Bumps in Your Parking Lot?

• ​​Replacing your speed bumps.

As most speed bumps are made of plastic or metal, they are subject to wear over time. However, their ease of installation makes them the best candidate to be replaced on the road with concrete bumps. Once you see all or some of the pieces of speed bumps in your parking lot are worn out due to excess of cars crossing over them, you can get it replaced the same day within few minutes. 
​
In parking lots, it is necessary to install speed bumps so that no vehicle can over speed and can cause potential damage to a car or any pedestrian. It is best to seek the services of a professional who can rule out which material and size will be best for you to use in your parking lot before you make your decision. 

Weather in Ottawa, Kansas

​CALL TODAY FOR A FREE
LINE STRIPING QUOTE
Pavement Striping in Ottawa, KS.
(816) 844-6684​