Lenexa, Kansas Parking Lot Striping
Lenexa is a city in the central part of Johnson County, located in northeast Kansas. As of the 2010 census, the city population was 48,190. As a satellite city of Kansas City, Kansas, Lenexa is included in the Kansas City Metropolitan Area. It is bordered by the cities of Shawnee to the north, Overland Park to the east, De Soto to the west and Olathe to the south.
Fun things to do in Lenexa
Each June the city hosts "The Great Lenexa Barbecue Battle", which is also the Kansas State Championship. Lenexa was known as the "Spinach Capital of the World" in the 1930s and celebrates with the Spinach Festival every September. We love serving the businesses of Lenexa.
What are Speed Bumps & Which Traffic Control Device Should You Install in Your Parking Lot? Speed bumps belong to the category of traffic control devices which are used to slow down the speed of traffic. These are used all over the world, and their primary use is in areas where a low-speed limit needs to be followed. Speed bumps have proven to be very useful in controlling the speed of the cars that drive over them. The height of a usual speed bump lies between three and four inches. The length of the bumps can vary, however. Usually some space is left between the bump and the edge of the road. There are many other variations when it comes to speed control devices. Some of which are speed humps, speed cushions, and speed tables. Why You Should Hire a ProfessionalWhat are Speed Bumps Made Of? Speed bumps are made of rubber, plastic, asphalt, metal, or concrete. If they’re made of rubber or plastic, it’s easy to get them installed on existing surfaces for a quick and effective setup. Despite being a simple task, there are some basic instructions that need to be followed before installation. If these steps are not followed, a severe accident can happen. The surface where the bump will be fitted should be clean, dry, and smooth. If there is any damage, it should be repaired before a speed bump is installed. Speed bumps should lie flat on the surface. Once the position is marked, speed bumps should be drilled and fitted on the ground. When to Replace Speed Bumps in Your Parking LotSince most speed bumps are made of plastic or metal, they are subject to wear over time. However, their ease of installation makes them the best candidate to be replaced quickly and effectively. Once you see that the speed bumps in your parking lot are worn out due to excess traffic crossing over them, you can get it replaced the same day within a few minutes. In parking lots, it is necessary to install speed bumps so that no vehicle can speed and can cause potential damage to a car or a pedestrian. It is best to seek the services of a professional who can decide which material and size will be best for you to use in your parking lot before you make your decision. Current Weather in Lenexa, KansasComments are closed.
|
Archives
November 2019
Categories |